Car Decal | Shield "Archery"

Easy-to-apply custom cut decal

• Standard 5-6" size

Instructions for Vinyl Decals

Surface must be clean and free of all moisture, oils, and dirt.

These decals come in three layers:

1. The top layer is called transfer tape. It looks somewhat like a clear masking tape.
2. The middle layer is the actual decal.
3. The bottom layer is a backing paper treated with a release agent.

You will need a credit card or a similar plastic squeegee. Decals are applied best at room temperature or warmer (not in direct sunlight). Take credit card and flatten from both sides by rubbing over the decal. Make sure all bubbles are released. Turn decal upside down and pull backing off slowly. Hold edges of letters and all small areas while pulling away the backing. If a letter moves, just position it back into place by pushing the backing down onto it. Position decal and flatten from the center out. Use credit card again to flatten as much as possible. The transfer tape will allow you to rub the decal without damaging it. Peel back edge of transfer tape slowly, watching for small letters and corners to make sure they are stuck to the glass, and not to the tape. Take your fingers and check all edges to make sure they are tightly applied.

Once the decal is applied, it cannot be moved again.